Recent content by champ_white_FL5

Do you know the dimensions of the included filter? I couldn't find anything on their site and would like to use an AEM filter in place of the MST one.

Did you notice any power loss? I know the AEM is more restrictive, but not sure if it's enough to choke the motor at all

Nice! I did notice some dust in the plastic intake elbow after using the PRL filter. I'll switch to the AEM soon and see how it fares.

Any dust or bypass issues? The seal had me a bit iffy on the AEM since it's slightly oversized.

I've been interested in the MST intake as well! Trying to confirm fuel trims as well as the filter size. I'd like to pick up an AEM Dryflow that will fit. But don't want another PRL situation where the velocity stack is sized oddly and no filters really fit well except for the included one. And...

Stock tune and intake keep long term trims very close to 0. Usually in the negatives but +-2 or tighter. As you probably know, short term fuel trims fluctuate a lot more. With PRL HVI long term trims are a bit more loose on the positive side +3 or so, but short term trims seem to be a bit...

Never above +-5, usually+-3 or so.

TF-9007D is ever so slightly too tall. To get the air box lid on you have to force it. It'll fit, but the lid rubs on the top of the filter. This filter also caused erratic MAF readings for me. My fuel trims were all over the place and at one point the car kept dying right after startup with a...

Loosen the filter and rotate it 180°. Could be turbulent air coming through the filter and throwing off the MAF. It's unlikely, but an easy and free thing to try. I've had turbulent air flow coming through a filter cause the car to stall and throw that exact code. Swapped filters and it went away.

Thanks for sharing

4.7 long term is decent. Is this at idle? Does long term go down once you start driving?

Hey I'm no expert either, I just like to tinker! Using the AP200 might be easiest since it's a Bluetooth scanner that you can read on your phone. Add short term fuel trim bank 1 and long term fuel trim bank 1 to live monitoring. LTFT should be +-5 and STFT should be +-10 or so while driving but...

Have you checked your fuel trims? That might help you narrow down that MAF code.

Here's the inside of the plastic EVAP elbow after using the PRL HVI/filter for the past few thousand miles. Might switch to the AEM to see if it's able to keep the intake tube cleaner.

Eagerly awaiting fuel trim data!