Recent content by Contoso

Dang… I am, but put a hold on a watch the next day. I really shouldn’t have so many hobbies… That is supposed to land in early May but if it falls through for some reason I’ll let you know. If not, good luck with the sale! At least it’s not priced like the other one and shouldn’t see a one year...

Let me know if you decide you’re willing to ship and I may be a buyer. I’m only a state away so hopefully not an egregious price to do so.

Looks great and it’s nice to know someone is willing to do custom shift plates. I’ve been considering a gated manual plate for a while and plan to draft it up/3d print to conceptualize but wasn’t sure if anyone would be willing to take it any further.

Same. I reached out to them directly a few weeks ago to get confirmation and was ghosted. Though sometimes the lack of an answer is the answer after all.

If you’re curious what is available these guys are a good place to start and have a good reputation around these parts: https://www.chasingjs.com/category/fl5

Yep, sorry about the delay. Here you go.

Great pics, but I agree with you. Bit too much for my liking as well. Thanks, and GLWS!

Hm, I’ve been eyeing replacements for mine and leaning toward OEM CF but like that one. Do you have a straight-on pic from the rear?

Oof. Hard to say for sure on a tuned ECU, especially when the tool won’t connect. I’ve been amazed how many codes get thrown when the voltage is even slightly off so I’d start by checking or even swapping the battery, confirming you have no corrosion on the terminals, all grounds look good, etc...

This one? https://www.evasivemotorsports.com/store/product/voltex-type-2-1600mm-with-spl-mount-honda-civic-type-r-fl5-2023/

Yep, saw that and think theirs looks great, but why spend $23 when I can use my $800 printer, a kilo of filament for test prints, and multiple hours over the course of a week tweaking mine to look “just ok?” 🤣

Unfortunately no. Omitted from that picture is the C-to-A converter.

Yep, same here. Also, it may be hard to see in the pics but I settled on the puck being raised 1mm and added a 1mm negative at the back to account for the camera.

Morning, folks! I decided I was done with the garbage charge pad but also didn't want to fork over a ton for the Canadian version and some of the other options I've seen around, so I decided to learn just enough about 3d print design to make my own and am sharing the model here for others if...

Man, I’d love to take that off your hands but that asymmetry would drive me insane. GLWS!