I've been tracking down this rustling/rattling noise and discovered while washing my car today that this piece of trim is loose. It's significantly looser on the driver's side. I haven't hit anything so not sure what happened.
Anyone else have this issue and, if so, what did you do about it?
Noticed a rattle on my door and saw this
Just had to replace the trim around my steering wheel because it melted. Not impressed with the interior plastic quality.
My infotainment screen makes clicking/cracking noises every single time i drive over a bump in the road. seems to be worse when the car is hot. I took it in to the dealer a month ago and they said they put some felt tape in some areas but there is zero improvement. Anyone else have this...
Just wondering if this is normal? I've seen some other posts of people's rear skid plates sagging in the same spot. Is it supposed to be like that? It hangs lower that the passenger side.
edit: forgot to get a pic but will upload tomorrow
It was raining and my foot slipped off the clutch pedal while clutched in in 1st gear around 5mph. Car jolted and heard a very loud bang. Could this have damaged anything? Or is this just the flimsy stock RMM bottoming out?
Tried taking a picture of it (too blurry), tried flashlight (too steep of angle to read), any other ideas? am i going to have to remove my damn airbox?
can i see it via Ktuner or a scan tool?
do i need to hire a contortionist?
maybe i just need to try again in the daylight and try zooming...
Anyone try the new shift kits from Acuity?
Stage 1: https://acuityinstruments.com/collections/11th-gen-honda-civic-2022/products/stage-1-shift-kit-for-the-11th-gen-civic-and-5th-gen-integra
Stage 2...
What's everyone's favorite MTF? Has anyone tried a bunch and have a favorite? The Honda MTF feels so thin especially when it gets hot. I miss the butter smooth shifts of my past cars gearbox's with 90 weight fluid. feels like i have to be super gentle with this thin stuff. maybe i'm just...
I'm looking at buying a new ported/CDV-deleted slave cylinder. there's a few available for 10th gens but i'm wondering if the 10th gen slave cyilnders would work on an 11th gen? Does anyone know if they are compatible...
I'm looking for a solid phone mount that attaches to the dash. Currently have an iOttie Easy One Touch (suction cup, windshield mount), but it tends to rattle around on bumpy roads and interferes with my sunshade. Want something that attaches to the dash. Don't want a windshield, vent, or...
Anyone install the Powerflex insert on their rmm? Having trouble getting it to fit. Do I have to remove the little rubber flap on the engine side? It seems to be in the way.
After doing a couple oil changes and installing a RMM i noticed the front lift point appears to be dented/collapsed inward. Can this effect alignment in anyway? Is it designed to collapse a bit after a lot of use? I used a thick rubber jack pad and always made sure it was centered on the...
2022+ Civic PRL rear motor mount. Installed three weeks ago and had it on for about 1200 miles. Like new condition.
Dramatically improved all shifts (especially the 1-2 shift) but the NVH at idle with A/C was annoying to me. It wasn't bad but I liked how smooth the OEM mount was. Got...
I ordered a silicone license plate frame to get rid of the dealer frame. Installed it with the rear license plate. Went as smooth as you can expect installing something as simple as a license plate. Didn't hear anything break. Looked down when I was done and found this broken piece of...