Recent content by TypeOne

This is an interesting test. Did you end up painting an entire wheel?

Swift springs ride fine... I just had FK8 springs and ran too much camber. The ride quality was not good. Swift springs that are designed for the FL5 are great. Also... this car doesn't ride good to begin with so it doesn't hurt the ride THAT much. Just wanted to clear that up. I think Swift...

Here's another shot

The film over my screen is just one from amazon for a 22+ Civic.

We are developing our own right now, I have the prototypes. The ride is SOOOOOOOOO much better than with my spring setup. I can drive the car without my spine breaking now. More info to come though.

Added a bit of dry carbon to the interior as well. All in stock at Hybrid Racing

Two tone - red/black Garage Unique Lip added, installed coilovers and paint matched the rear wing.

I had adjustable top camber plates because I pulled them from the old FK8 parts bin that I had at the shop. Camber was -3.2 in the front and did not rub.

Thanks dude!

Added a larger FMIC and our new prototype Ti lugs.

Yes they are.

Took a picture

Added a Garage Unique Carbon Fiber rear wing to my FL5. Going to make some wing stands next. https://www.hybrid-racing.com/products/garageunique-rearwing-fl5-civic-type-r?_pos=2&_psq=gar&_ss=e&_v=1.0

Make sure you have connected the remote key sensor. It's inside the console near the right side of the shifter. That might be your issue. Step 8 - https://guides.hybrid-racing.com/Guide/How+to+install+HR+Short+Shifter+22++Civic/396?lang=en

Total clearance in what way? The lip is about 2 inches from the ground.