No, I installed as per RV6 manual although I found it very sketchy to do without dropping the subframe.
Either way, poly bushings can spin inside the housing so it is not necessary to torque them with load.
Still I got my ass kicked by my Associate by 3 full seconds on a 718 GTS. lol.
Of course it is out test bench as well and the development on that platform is great.
I ran on used 265 Pirelli DHF´s on 4 corners but with very little rubber, but next time I will try new yoko 280´s up front and...
About my build — a few days ago I saw a post from a famous "pro tuner" saying that the ECU was designed to operate with a MAF and that only hackjobs delete it.
Well... he has no clue.
The MAF sensor is not used directly to calculate load. On Bosch ECUs, the MAF is used to calculate manifold...
Unfortunatelly, this thread has 28 pages and I don´t think we are going anywhere.
It’s been over 2 years since the FL5 came out and people are still ignoring the real problem.
What’s the point of doing a 3-pass radiator, if all it does is make the system worse?
You guys still don’t get how a...
the cool part of it is that they located who did the welds of that exhaust at the factory, and found out that 4 other exhaust welded by that person that week failed. So they recalled all exhaust and fired the woman
I had to locate a titanium welder once and take him to the track to weld a brand new GT3 akrapovic exhaust the blew one resonator cap at the track. Next morning he had to go again to weld the other side. lol.
Interesting. I do notice the car overload the front end sometimes, but it feels like it has too much grip on the rear. Maybe running bigger tires on the front could help launch the rear a bit more.
On street tires though, the car behaves more natural
In regards to the main topic:
Progress is not as fast as it was before, but always moving forward. I have implemented flex fuel in my patch, using ECT2 as analog input as Hondata did on the fk8.
I never had time to integrate the reflex+ via can, but I ended up makin my own board to control a...