Search results

I know this is an old post but I really like thi setup. Did it rub when you had it. Any bodywork or alignment needed?

Interesting because I used to siphon out about 1/2 of a quart of oil out after every dealership oil change (so about 5.2qt left in the pan) and it’s usually spot on the max line on the dip stick following proper measurement from the manual. At this point I just don’t know what to trust lol. The...

Yea I think I have tried driving it up to temp and waited approx 3 min like the manual said but it’s still slightly high. The small shop said they put about 5.7 quarts which is the recommended amount but the dip stick will always will be fully submerged. I just don’t want my crank to whip the...

have you checked the back side of the dip stick usually the front side( the side facing the windshield) is very inaccurate. But if that’s the case it might just be the horrible dipstick or something else. Should I siphon some out or is it just inaccurate reading?

I have changed my oil numerous times at the dealer and noticed they always overfill the shit, and I have to siphon it out. Today I went into a smaller shop and had the oil changed again, and they told me they put in about 5.4 liters or 5.4 quarts. After I drove back took another look at the oil...

How tho I looked at some YouTube videos and it didn’t look too bad it was just some clips and screws. They said it was easier than the FK8. How long do you think it will take to fix the alignment from the shop because this car is my daily

I appreciate it. The first picture kinda looked like something similar to my driver side (right) bumper. Are these mounting brackets made of play dough it just sags overtime Imao

I just contacted the shop and they said they are going to take a look at it. The left side is bad to the point I can fit a finger nail in between. The right side is just slightly popped out. But is the color mismatch that bad? I heard it’s normal to have a slight mismatch because the car is...

My car got into a small front accident where they had to replace the front bumper but lately I noticed a decent gap after they fixed it. Just wondered if this is acceptable or not because fl5 is known to have panel gaps. Thanks

Hey guys I recently changed my intake but needed to swap back to my stock air-box but lost the o ring gasket under the jet purge valve and I can’t find a part number for the correct size of the O ring. Currently I just used some RTV and sealed it off ,but It would be great if y'all know a good...

Lately, I've been eyeing some lip splitters for my Type R, and all the ones I want are over $600, so I decided to create my own DIY Splitter using ABS plastics. However, I encountered some issues when locating the mounting points for the lip. I tried to copy some of the pre-existing online lips...