Search results

That's definitely the case. The metal ones will be much stronger. I used some ironing on the top layer to strenghen the bonding between the lines. Initial thought was if it breaks I can just replace it, but the clips are so annoying lol. Broke one finger removing the clips so hopefully it can...

For real, even hurt my finger removing these. Gladly now it's done

Don't want to pay $70+ for a part that is meant to take damage, so decided to make my own. After many revisions and tests, finally installed my 3D printed ones on my FL5. I'd like to share some thoughts on how to get the best print. First of all, I used a paper and pencil to trace the outline...

Very interested! Any idea on how bad is the dirt/snow build up with daily driving in the Winter?

Heat is definitely an concern. I used some pretty viscus lub. That rear mirror area can get pretty hot just from the honda sensing camera. We will see how it goes - might need fix it again in the Summer.

I've been noticing the a lot of rattle sounds ever since I owned the car. After I fixed the B-pillar, it was good for a while - until I recently replaced the rear motor mount. After intalling the PRL rear motor mount, I've been hearing a lot of rattle coming from the passenger side, especially...

Using the same catch can, about half can of oil ~7000 miles.

Update: successfully took out the bolt, the size is m6 is anyone have similar situation.

Thank you I will get a try tomorrow

when I was installing the intercooler today the 10mm bolt holding the top connector snapped. PRL calls for 18 lb ft for both the 10 mm (which the manual says they are 12 mm). Please don’t torque it too much when you install yours! I don’t think this bolt is important so I am leaving it as is...

Dealer emailed me today saying they can track it in system now, ETA 1/26-30. Location PA.

Yeeahh great news to hear! You're the man!

Thanks man!

Thank for doing all the work! Mine is 1033 shoul also be on Iris Ace, can you check if it has a railcar #? Much appreciated!