• Welcome to CivicXI.com everyone!

    If you're joining us from CivicX.com, then you may already have an account here!

    As long as you were registered on CivicX.com as of May 24, 2020 or earlier, then you can simply login here with the same username and password!

Search results

  1. Audio Update, Bad News

    I did not confirm that, although my collection of tools is sufficient, I do not have a way of testing the coax. Only thing I did was unplug it and confirmed that audio no longer worked and plugged it back in.
  2. Audio Update, Bad News

    The stock amp is up in the corner of the passenger kick well near the front passenger fender, way up behind the glove box. I don’t believe it is optical, I may be mistaken, but if I remember correct it is a digital coax feed
  3. Audio Update, Bad News

    So when it comes to the center speaker, I completely disconnected it. Unfortunately that center speaker plays both music and all voice for phone calls, navigation etc. I’m currently living without but will eventually figure out a solution to retain it. The amp does become quite hot at higher...
  4. Audio Update, Bad News

    Hey buddy, sorry been off the forums a bit. My current amplifier setup consists of a Sundown Audio SIA-3500 for the sub stage, and a Rockford Fosgate Prime 75x4 fully active. The Sundown Amplifier is hidden beneath the trunk false floor in a spot I carved out of the foam and applied a mounting...
  5. Audio Update, Bad News

    Old Update: The Si does feed its factory Bose amp with SPDIF. I learned this a while back and was using an AudioControl LC7i and Dayton DSP-408 using high level in from the rear doors and sub. Since then I got rid of both units after having more issues with the Dayton 408. I moved to an...
  6. Audio Update, Bad News

    :hmm: hmmmm. now you have me interested. I'll have to look into that
  7. Audio Update, Bad News

    I mean it’s not a horrible concept. Having half decent amplification and a good source does make stock speakers sound better. But definitely not my jam. I’ll be taking out all the speakers and running my own stuff
  8. Audio Update, Bad News

    I pulled door panels and took the speakers out and looked at them..
  9. Aftermarket Clutch

    With the 22 Si having a single mass flywheel, is it necessary to change the flywheel when moving to an aftermarket clutch? I was considering getting an ACT clutch and my Si would be fairly low miles (<10,000) by the time I pull the trigger. Only plans are intake, DP, FP, exhaust, intercooler and...
  10. Audio Update, Bad News

    Hey guys, I did some probing with my oscilloscope today and came to a saddening realization. The headunit outputs audio to the factory Bose amp via a coaxial digital signal. There is CURRENTLY no way to tie into the system using a DSP pre-amp. So until iDatalink releases an interface (if at all)...
  11. ASC Active Sound Control delete on 2022 Civic Si - DIY how-to

    Good day everyone. I haven’t seen a thread yet for a little guide on “deleting” the Active Sound Control on these new Si’s. So I figured I’d share some pictures and my experience. To begin, I pulled out the glove box, popped off the right triangular trim piece facing the passenger door, dropped...
  12. Be careful...

    Okay here is the scoop, the window is being warrantied. Although, the glass is on backorder. I am being told by the dealer they are "trying to have it expedited", I take that with a grain of salt. But my personal glass guy said they same thing about that glass being on back order so I know they...
  13. Be careful...

    I took delivery of my BOP '22 Si on 03/23/22 and drove it a few days, took it to work, etc. Well, after working night shift on 03/27/22, I get out to my car, sit down inside, close my driver door and BAM! the front passenger door window shattered. It was only 22F outside. Car only has 475 miles...
  14. PRL Motorsports 11th Gen 2022+ Civic Si Baseline Dyno Test

    KTuner just released their baseline tunes today, might be worth looking at also
  15. 2022+ Civic Si Shift Knob

    I don't mean to be that guy, but I will be for a moment. I'm a customer of WC Lathe Werks and I love the quality of his shift knobs. All hand made in house on a lathe, he does shift pattern engraving and leather wrapping and more. One man band. Very similar looking shift knobs can be ordered...


Top