Search results

The valve is controlled by RPM, throttle position, as well as the "Engine" setting This post has the various valve positions across different drive modes: https://www.civicxi.com/forum/threads/there%E2%80%99s-a-reason-honda-made-active-exhaust-don%E2%80%99t-disable.53334/post-887033

I tried the Spigen screen protector on my FL5, and ended up removing it after a few minutes as it made the clarity of the screen worse (matte screen protector + matte finish on the OEM screen). I now don't use a screen protector and havent noticed any scratches on it yet

It may be possible but I wouldn't. jack the back, replace back with the spare. Then lower car and jack the front and replace the flat with the wheel from the back.

This should stop any hail from hitting it...

If you get a flat on the front you can just swap a rear tire to the front and put the spare on the back

Apparently this BMW spare will fit under the trunk floor without raising up the floor since the wheel is only 5" wide.. has anyone tried it in their FL5? https://www.integraforums.com/forum/threads/a-spare-tire-that-fits-under-the-load-floor.51812/

does the sound change at all if you close the air vent?

The worst part of this post is the 30 seconds I will never get back

Is it only when turning? My steering wheel creaks a little when turning, and the airbag cover makes “clicks” whenever I hit bumps

Thanks for the charts. Do these correlate to the "Engine" setting or the "Engine Sound" setting? I haven't found a definitive answer on which setting changes the valve behavior

My left side mirror does this too and it drives me nuts. If you push on the glass while closing the door the sound goes away

They just emailed me and said the ETA is 04/05/2024 and expect to fulfill their entire back order as of now

ill take it Edit: @Ultimateone beat me to the punch. Ill take it if they dont!

I used some sharpie as well. The color matched fine but it still has a rough texture, and has to be reapplied every few washes :D

Has anyone managed to repair minor curb rash on their FL5 OEM matte black wheels? I have a minor rash on one of my wheels and was wondering the best way to repair them as it has a matte finish. Is there a Honda paint code for the wheels for finding some touch up paint?

Why not just put the engine sound in comfort?

How hard is the install? Do they provide instructions on how to install it?

Looking to buy an ITS ADS module off someone who may have done the swap but prefers the FL5 ADS Unit. Thanks!

I drove my type R 8.5 hours back home from Ohio and it was a great experience getting familiar with the car and also knocking out the break in miles.

This is probably my favorite exhaust for the fl5 Ive heard so far. However it sounds like there is some rattling/vibration noise, can be heard around the 1:30 min mark in the video. That would drive me nuts