Search results

Yea its unfortunate and disappointing that a $2k bar company didnt thought that through. I can always get a shop to bore the extra space needed but do I want to destroy a $2k piece?

So what happened was without the alignment pin, when you remove the 3 strut nuts, due to the weight of the car, gravity will pull down on the strut thus shifting the strut into max camber position because the strut hole on the chassis is Oval shaped, not circle. With the studs being shifted, the...

This finally came in. Been waiting for this and im excited that its finally here. WCLatheWerks SpoonSports Ti burnt Replica shift knob. Its a little bigger and heavier than the original design requested by me. I liked the acuity knob tbh but I want something that not many people have but still...

R1 titan titanium strut bar unboxing

Yup 40 of 100

My buddy was able to reinsert the strut pin in. Turns out all you need to do is to hammer it back down in place lol then got the R1 Titan Titanium Strut bar (040/100) with Chasing J's titanium burnt nuts on with an alignment done at the same time.

Dressupbolts up front

Verus MC brace

Got the hasport rear engine mount and wot cooling plate installed

Got some Chasing J's titanium exhaust stud kit, strut nut kit and dip stick. Figure since I've seen alot of ppl breaking their studs on the turbo part, id get them replace when I get my front pipe and catback exhaust swapped out when the time comes. But I swapped the dip stick as of now and its...

idk about fk8 but i did noticed that ever since the fl5 came out, almost all aftermarket parts for it has been through the roof. companies are charging an arm and an leg for it like its an exotic car. i guess it being the last ICE CTR and pretty much the best CTR up to date, the most elegant CTR...

No more dropping my phone in the crease!

i just might do that when or if i switch out my shift knob

Next up is I added the jdm subaru trash bin or storage bin which I will be using as that. I have a couple of these and since I dont feel like theres any good storage in the fl5, I decided to put one of these in cuz why not and jdm points. Usually these go on the passenger side of the center...

Acuity Instruments have arrived! It feels good to have their products in my car again. As I've had some of their stuff in my fa5 before. I got the shifter base bushings, shifter collar and pedal spacer. Only got to the small stuff today as I wanted to put the center console back together asap...

Fun fact, I've had this set for like 4 years now because I knew back then that I was going to have another jdm car one day as I wanted an s2k or the fk8. The flare holder is a genuine honda part and I have a set in both of my other subarus. I was looking at some install instructions of the other...

Illum center cup holder and storage. There's two Light A, one Light B, one Wire A, one Wire B, 2 garnish A, 1 garnish B and 3 screws. Remove center console. Remove cup holder. There are already templates of the holes that need to be drilled stamped onto the bottom of the cup holder storage bin...

Next is the mikstore a/c vent. Remove the center console out. Pull the rear cover off. Remove both vent up front, the one with the single outlet and the one that feeds into the floor. Swap over to the mikstore vent with the two slots (one for floor stock position and one to the rear). It has 4...

Small write up in picture form of the installation of the illum Type R door sills. . type R sills: start by removing the side trims and kick panels and under panels on both sides of the cabin. Clip in the harness under the steering wheel column behind the 2 white harnesses that are next to each...

Rear mirror brand new $50 pickup in chicago $60 shipped