What did you do to your FL5 today?

[Zone47]

Today I tried another brand of consumer ceramic wax or whatever you want to call the stuff. It's made my Nu Finish and supposed to last for a year. After using the Turtle wax hybrid solutions for a while, I think the Turtle wax is better, it seems to leave a smoother finish, but it is more streaky on black, so I have to damp towel it again after I'm done. The Nu Finish is less streaky but don't leave the paint as smooth feeling.... Maybe I should just buy a pro kit and get it over with.

Tonight went out on a cruise and nailed it in 2nd gear. Holy crap is this thing fast when the air cools down!!! It was 66 degrees out and felt like I had another 25 hp.

Sponsored

 

[RUNN1N]

I haven’t messed with my FL5 in a minute, but I did do a FL5 things to a couple hats!

If anyone else would like pins, just $20/set including US shipping—shoot me a message!

 

[ram3noodles]

Installed some matte carbon cooling plates since i am stuck waiting for my Infinity Design's intake and top pipe.

where are the cooling plates from?

 

[Dustbunni]

where are the cooling plates from?

A guy from infinity design hooked me up with him on Facebook!

 

[Andjoo]

Gave the R a little more tone

 

[TW00Si]

Put the APR rear sides on. Decided not to drill into the bumper so it’s held on with one screw and double sided tape. I think I need to take off the rear mud guards. Not sure if I like it.

 

[DR_FL5]

 

[TW00Si]

Put in Lasfit LED turn signals and reverse lights. They are bright. Very bright. Will come in handy when I have to do the 24hr of Lemans.

Also installed the third brake lighter flasher mod from @NHCivicGuy the install requires taking off the three pieces and cutting parts of the rubber gasket. But you can tape it and still clean it up a bit. The install is a lot more involved than I had anticipated. Each piece of the light are held in by 3 8mm nuts and clips.

 

[svvitch]

@TW00Si thank you for this. Another part to sit on my shelf until it cools off a bit outside

 

[TW00Si]

@TW00Si thank you for this. Another part to sit on my shelf until it cools off a bit outside

Which one are you doing? The bulbs are easier. The reverse being more accessible. The turn signal, not so much. Have fun pulling the 3 pieces out. They were no fun.

 

[svvitch]

Which one are you doing? The bulbs are easier. The reverse being more accessible. The turn signal, not so much. Have fun pulling the 3 pieces out. They were no fun.

I bought the flash module thing.

 

[TW00Si]

I bought the flash module thing.

God speed.
The metal frame under the black plastic panel is not smooth.

 

[FoxtrotLima5]

New Wheels - CE28Nplus / project kics lug nuts

 

[mpower]

Put the APR rear sides on. Decided not to drill into the bumper so it’s held on with one screw and double sided tape. I think I need to take off the rear mud guards. Not sure if I like it.

Your car NOT lowered right?

 

[TW00Si]

Your car NOT lowered right?

No, stock suspension.

Sponsored