RV6 rear sway bar + billet endlink noise

[ttccnn49]

Hi all,

I had my RV6 swaybar installed with rv6 endlink. the whole setup looks solid... and sounds very solid as well.

When I driving slow in the community and in the parking lot, I would hear all sort of squeaking and clacking from rear. My wife keeps asking me if my car is broken... once I drive over 40mph, I dont hear any weird sound. (may still be there, but other sound is loud enough lol)

Is this because of the billet endlink? it looks to me like metal to metal contact without any damping.

Thanks in advance

Sponsored

 

[ctechauto]

Normal and expected. Any solid joint (heim/rose or solid bearing/bushing) will introduce additional NVH compared to a greased ball joint or rubber bushing. The trade-off is increased articulation, increased durability, increased feedback and 'directness' to the driver.

 

[Two Step Performance]

I can confirm this is typical.

 

[ttccnn49]

Thanks to both of you. Would it be less noise if I use the stock endlink?

 

[coolnick]

Yes, it would be zero noise if you used the stock endlinks. Just to be sure, you might want to get under there and check that the bolts holding the bar to the chassis have not come loose. Mine got loose a few days after initial installation and was making an occasional noise like you describe. After fully torquing them the second time, they haven't come loose again and it's been about 10k miles since.

 

[AspecR]

Hi all,

I had my RV6 swaybar installed with rv6 endlink. the whole setup looks solid... and sounds very solid as well.

When I driving slow in the community and in the parking lot, I would hear all sort of squeaking and clacking from rear. My wife keeps asking me if my car is broken... once I drive over 40mph, I dont hear any weird sound. (may still be there, but other sound is loud enough lol)

Is this because of the billet endlink? it looks to me like metal to metal contact without any damping.

Thanks in advance

You sir have entered the wonderful world of spherical bearings/rose joints/heim joints, this is normal with those components.

 

[V3N0M_VZL4]

Double check the torque specs, and add a little bit of loctite medium "blue" in the thread if possible.

Sponsored