MooMoo

Senior Member
Joined
Apr 6, 2024
Threads
13
Messages
998
Reaction score
924
Location
NY
Vehicle(s)
2024 CW FL5 Type R, 2002 Range Rover P38
@Robo7
Here are a few videos. As I mentioned previously, sound is hard to capture without proper audio equipment. Anyhow, better than nothing I suppose. The drive by/in-car videos will be made at some unknown point in the future.

Stock


Fujitsubo A-RM+C Titanium Exhaust + Front Pipe


Fujitsubo A-RM+C Titanium Exhaust + Front Pipe


The third video is a better representation than the second since an external mic was used. My installer was able to film this video a couple days after installation. FYI - All videos are cold start - car was sitting for days before starting. The car has a Spoon Air Cleaner only.
Its hard to hear the difference on the videos but I bet its there and its not a bad thing. Just a little louder than stock is perfection. This also looks really nice, tips seems to fit great and look great
Sponsored

 

evlsmurf

Senior Member
Joined
May 18, 2017
Threads
10
Messages
275
Reaction score
230
Location
NY
Vehicle(s)
2016 Subaru Impreza Sport
Can't wait to hear this, valved and under $1500 is pretty nice.
Do the tips sit out more vs OEM? is there any adjustment?
Um, not sure if they stick out more. The center pipe can't be adjusted. The side can. I decided to put them back from the center.
 

TW00Si

Senior Member
Joined
Aug 14, 2023
Threads
8
Messages
1,276
Reaction score
1,302
Location
NYC
Vehicle(s)
2007 S2000, 2023 CTR
Played out or not. TE's have been my favorite wheels since the 90s lol.
Doesn’t matter if it’s played out. As long as the owner likes them.
I thought Mugen MF-10 was rare until I saw at least 7 sets at Honda Fest. That is also played out then. Lol
 


SKINNIE

Senior Member
Joined
Jan 18, 2023
Threads
2
Messages
328
Reaction score
398
Location
DFW TX
Vehicle(s)
ISF, 23' BB FL5
Doesn’t matter if it’s played out. As long as the owner likes them.
I thought Mugen MF-10 was rare until I saw at least 7 sets at Honda Fest. That is also played out then. Lol
I've had a set of TE's on every car I've owned. I might switch it up and go with something else that's played out with this car lol
 

TW00Si

Senior Member
Joined
Aug 14, 2023
Threads
8
Messages
1,276
Reaction score
1,302
Location
NYC
Vehicle(s)
2007 S2000, 2023 CTR
I've had a set of TE's on every car I've owned. I might switch it up and go with something else that's played out with this car lol
Just make sure the car itself is not played out.
 

50Cal_Actual

Member
Joined
Apr 13, 2024
Threads
0
Messages
20
Reaction score
16
Location
Virginia
Vehicle(s)
2024 CW FL5
I installed the newly released Invidia R400. It sounds amazing. It's a pretty loud exhaust, so there is definitely some drone. It doesn't bother me, as this is not my daily. I ran it on my FK8 as well. I wanted an exhaust with the titanium burnt tips. It's also valved, which is nice.

Thanks to Josh at Meraki Autoworks for hooking me up with the exhaust. It took a while to get, but Josh was great to work with.

I also installed the PRL RMM while I was under the car.

Would LOVE to hear it! Looks phenomenal and I've really been looking forward to this releasing.
 
OP
OP
Icehawk

Icehawk

Senior Member
Joined
Mar 19, 2022
Threads
12
Messages
644
Reaction score
787
Location
Miami
Vehicle(s)
2023 CTR #3177
I'm kinda surprised that folks putting in new crossover tubes aren't wrapping them with DEI foil, I get it will hide the bling but I would expect it to help with temps. Plus the foil is its own kind of bling anway. If the OEM one was conducive to it I'd have mine wrapped.
 


matttheazn

Senior Member
Joined
Feb 20, 2023
Threads
11
Messages
77
Reaction score
22
Location
MO
Vehicle(s)
FL5
For the tail light kit install, does the wiring harness plug into the LED Room Lamp (08E13-E4A-A00)? Does it split off of that plug? Do you then route the led connector for the tail light up through the hatch? I am wanting to order this but trying to figure out how to install it. Thanks for any advice.
 
 







Top