OEM+ Style Build

[iforgettopee]

drop looks good - just put some weights in the trunk to level out the rear haha
you could also play around with a thin spring pad for the rear spring too (maybe remove it all together if you're not worried about noise)

assuming the rear spring pad is the same as the FL5 - I measured it at 60mm ID x 90mm OD
I bought a thicker "rubber o-ring" off ebay to raise the rear of my car

Sponsored

 

[HKSpeed]

Installed Si front calipers, pads, and rotors. Si is 12.3". Non-Si is 11.1". Si pads are wider and taller. Only modification is bending back the dust shield. Reused my stock brake lines and banjo bolts. 2022+ Si front brakes are also found on 2023+ Acura Integra (not Type S) and 2018+ Accord Sport/Touring. I didn't notice an improvement after 50 miles of daily driving, which didn't surprise me. I did this mod for modding sake.

 

[HKSpeed]

Been 5 months since my last post. No major additions.

I painted the mirror covers red. I also added a SpoilerKing upper hatch spoiler, painted white.

I recently replaced the faded and cracked front lip with a fresh one (same design).

Got a Hawkdown knob, which is a copy of the Battlecraft knob.

I'm down to 4 knobs. I sold the Spoon (too thin) and Acuity (too thick).